New long pips from Reach - for choppers ?
Posted: December 17th, 2025, 6:08 pm
New actual non-ITTF long pips rubber
From the makers of C-8 & C-801 popular actual non-ITTF long pips
Could this be finally a chopper rubber ?
Reach long pips - Ali Express
Pip length = 3.00 mm
Pip width = 2.2 mm
Aspect ratio = Height divided width =1.36
It says pip top is octopus claw. Looks like rough pips.
If so it may be for away from the table choppers
From the picture the pips seem closer (it is hard to tell ..I could be wrong)
If so then another + for choppers
Horizontal alignment
Another + for choppers
I would have liked it a shorter pps length around 2.5 mm with an aspect ratio of 1.5
This gives a pip diameter of 1.67 mm
If any of you ordered this and tested it , please post a review
From the makers of C-8 & C-801 popular actual non-ITTF long pips
Could this be finally a chopper rubber ?
Reach long pips - Ali Express
Pip length = 3.00 mm
Pip width = 2.2 mm
Aspect ratio = Height divided width =1.36
It says pip top is octopus claw. Looks like rough pips.
If so it may be for away from the table choppers
From the picture the pips seem closer (it is hard to tell ..I could be wrong)
If so then another + for choppers
Horizontal alignment
Another + for choppers
I would have liked it a shorter pps length around 2.5 mm with an aspect ratio of 1.5
This gives a pip diameter of 1.67 mm
If any of you ordered this and tested it , please post a review