Table Tennis iocTT.com :-Most advanced discussion forum.Free membership to join & post. Easy & simple registration. No email needed.

I have not tested these two rubbers but these two seem to have some potential based on their primary listed pips design parameters.
Most others seem to be for blockers because the pip density seems to be low and or the pip tops are too frcitionless

Click on link 1 > RAWARONTEXX
Click on link 2 > RAWARONTEXX

Pip length: 3mm
Pip diameter: 1.6mm
Aspect Ratio = 1.875 (3 mm/1.6 mm)
Distance between pips : 1.5mm (Good pip density . May be good for choppers for higher back spin)

=========================
Click on link 1 > Sabotase
Click on link 2 > Sabotase
Pip length 3.2mm
Pip diameter 2mm
Aspect Ratio = 1.6 (3.2 mm/2 mm)

I will see if I can order a bunch of these to test two items & few others & then post the results of test.
There seems to be tons of suppliers for each of these real long pips. I have no idea which of these are good at overseas shipping or are not shady sites
I am very surprised no one has taken up distributing these in places other than South East Asian especially in Europe.

Even if you are too much of a sissy to try to use these in ITTF touurnaments or even leagues, it wouldne great for pips players , especially choppers to clearly undestand how much the ITTF is ripping you off by performing comparison tests against the useless slim pips on ITTF LARC

If you any of you have played with these rubbers, please post a review here

Most of these rubbers also seem to be availanle in at lest four colors red , black, green and blue
Some may be available in pink & violet
Some were in yellow as well